Home > Exhibition > Content

how to install undermount sink

May 19, 2017

1. Install the faucet into the pipe

will be installed in the faucet in advance connected to the inlet of the water switch, installation should pay attention to the cohesion of the firm, but also pay attention to a detail, that is, the location of hot and cold water pipe, do not make a mistake.


2. Installing the water pipe with overflow hole

Overflow hole is to avoid the water tank to overflow the protection of the hole, so in the installation of water pipe overflow hole, to pay attention to the sealing with the groove body, to ensure that the overflow hole of the water pipe itself does not leak.

3, install the filter basket under the water pipe

In the installation of the sewer pipe under the filter basket, the main attention is attached to the connection between the water pipe and the groove body, not only to be firm, but also to be sealed.


4. Install the whole drainage pipe

Usually people will buy two filter basket sinks, but two of the distance between the water pipe, the workers in the installation, will be based on the actual situation of the drainage pipe to be cut, at this time to pay attention to the sealing between each interface, the common leakage problem occurs in these joints.

5. Install the hanging piece to strengthen the trough body

After the sink into the table, the need to install in the trough and the table supporting the hanging piece, the sink will be installed firmly, to avoid a small gap caused by the groove sway.