Home > Exhibition > Content

how to install countertop sinks bathroom

Jun 11, 2017

Before installing the sink, the faucet and inlet pipes should be installed. When installing the faucet, not only requires a strong installation, but also the phenomenon of water seepage at the connection. When the main assembly is recommended to install the necessary fixed parts for the pure copper or stainless steel, to prevent rust and rot. 

The After the installation of some of the functional parts of the tank is completed, you can place the sink in the corresponding position in the table, ready to start the next installer. 

Install the faucet into the inlet pipe. Will be installed in the faucet on the side of the inlet pipe connected to the inlet switch, the installation should pay attention to the convergence of the firm, not too tight or too loose, but also pay attention to a detail, that is, hot and cold water pipe position should be left Hot right cold, there are many families do not follow the norms to do, leading to water when the faucet handle switch thermostat in the opposite direction. 


The overflow hole is to avoid the overflow of the sink to protect the hole, so when installing the overflow hole in the water pipe, pay attention to its seal with the tank at the seal, to ensure that the overflow hole of the water pipe itself does not leak. It is best to seal with glass glue. 

Filter the basket of water pipes in the installation, the main attention between the water pipe and the convergence between the tank, not only to be strong, but also to seal. This is the key part of the tank often problems, the best care to deal with. 

Usually people will buy two filter basket sink, but the distance between the two pipes near the workers in the installation, according to the actual situation of the matching drainage pipe cutting, this time to pay attention to each interface Between the seal. 

Drainage test, until the basic installation is completed, the filter basket is also installed on the next step to start the experiment. To do the drainage test, the need to fill the tank filled with water, while testing the two filter basket and overflow hole drainage of water. Drainage, if found where there is the phenomenon of water seepage, should immediately rework, and then tighten the fixed cap or glue, to ensure that the future use of no harm.