Home > Exhibition > Content

Design and technology of flume function

Jun 15, 2017

The general water tank welding Close, no virtual welding. Welding quality is one of the most critical factors affecting the life of the flume, which is well welded and can prevent rusting and soldering. From today's trough market, any double groove depth of more than 18cm, are welded. The cost of this welding is high.

In addition, the sink thin edge workmanship, can be very good with the Mesa anastomosis, to prevent the junction of water seepage, even if there is water droplets, broken slag to the table, with a rag can be easily put into the slot, therefore, to pay attention to the thin edge of the flatness, because the thin edge to the processing technology requirements are relatively high, the thinner the edge of the more difficult to achieve flat.

Stainless steel sink Thin service life is short

When choosing stainless steel sinks, first look at the thickness of the stainless steel material to 0. Imm 1.0mm thickness is advisable, too thin affect the service life and strength of the flume, too thick easily damage the tableware.

Second, look at the surface treatment process, high gloss finish, but easy to scrape, sand light resistance to wear, but easy to gather dirt, matte light of both high brightness, also has the durability of sanding, general choice more.

The use of stainless steel sinks, the surface is easily scratched, so its surface through the wire drawing, sanding and other special treatment, which can withstand repeated wear, can also be more resistant to dirt, cleaning convenience.

The important reference index for selecting ceramic sinks is glaze finish, brightness and ceramic storage rate. High finish products, pure color, not easy to hang dirty fouling, easy to clean, self-cleaning good. The lower the water absorption rate the better the product.